Back to the work

Project story / Corvette ZR1

Scotty’s ZR1: From ProEFI to MoTeC M150

Scotty’s yellow Corvette ZR1 is back under the knife. Years after its ProEFI setup, the same car is now on a ProSPEED kit with a MoTeC M150 ECU. In this garage update, Roger talks through an E85 cold start, data logging, and what’s next for the car.

Watch the garage update Talk through your project
Current build · MoTeC M150 and ProSPEED kit

Current build / Hardware walkaround

MoTeC behind the fender

Roger shows the MoTeC M150 behind the front fender and explains how the RIFE module distributes 5V and sensor ground while each sensor sends its own signal back to the ECU.

Current build · MoTeC M150 installation detail

From Roger’s project archive

Earlier ProEFI setup

Roger rewired Scotty’s ZR1, installed ProEFI, and handled startup tuning. With the front fender off in this archive photo, you can see where the ECU and wiring sat on that earlier setup.

Scotty’s yellow Corvette ZR1 with the front fender removed, showing the ProEFI ECU and wiring
Scotty’s Corvette ZR1 Archive photo · Earlier ProEFI setup